(2) Eutech Microelectronics Inc (5) Exar Corporation (1) Extech Instruments Corporation. (1) Dialog Semiconductor (7) Diodes Incorporated (6) E-CMOS Corporation (9) ELAN Microelectronics Corp (51) Elantec Semiconductor (1) ELMOS Semiconductor AG (1) EM Microelectronic - MARIN SA (17) Emerson Network Power (1) EPCOS (4) Epson Company (23) Etron Technology, Inc. (5) DB Lectro Inc (1) Delta Electronics, Inc. (234) Cypress Semiconductor (14) Cyrustek corporation (3) DATEL, Inc. (10) Chicago Miniature Lamp,inc (3) Cirrus Logic (3) Clare, Inc. (1) Burr-Brown (TI) (2) California Micro Devices Corp (17) Ceramate Technical (2) Chi Mei Corporation. (1) BEYONDINFINITE (14) Bolymin, Inc (48) BOSER Technology Co., Ltd (1) BOWIN ELECTRONIC CO. (92) AZ Displays (119) BCD Semiconductor Manufacturing Limited (2) Bel Fuse Inc. (2) ATMEL Corporation (6) AU Optronics Corp., (48) AUK corp (2) AVAGO TECHNOLOGIES LIMITED (1) AverLogic Technologies Inc (4) AVX Corporation (2) Axiomtek Co., Ltd. (102) Aimtron Technology (2) Allegro MicroSystems (10) Alliance Semiconductor Corporation (11) Altera Corporation (62) AMIC Technology (3) Analog Devices (45) Analog Intergrations Corporation (2) Anpec Electronics Coropration (6) Aplus Intergrated Circuits (4) Applied Concepts Inc. (11) Advanced Analogic Technologies (1) Advanced Linear Devices (1) Advanced Power Electronics Corp. (1) ADL Embedded Solutions (1) Advanced Analog Technology, Inc. Back light jumper so you can adjust the brightness.ALL AAEON Technology (40) ABLIC Inc. Nate Benson from Ephrata, WA United States I currently have four of them running in my project, and they are working perfectly.īart demeulmeester from shawnee, KS United States The I2C backpack made this easy once I had set them all to individual addresses (via soldering jumpers) and had downloaded the LiquidCrystal_I2C library. I needed to be able to control several at the same time from an Arduino. I ordered a half dozen of these 16x2 LCD displays. I found an I2C scanner to run on an Arduino that pulled the correct address.ĭavid Mannering from Lawrence, KS United States The only issue I had is it had the wrong bus address on it. It was actually a bit of a pain to get going on an ESP32. The first LCD I bought didn't have the I2C interface on it. Keith Laymon from Hilliard, OH United States 0 of 0 people found the following review helpful:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |